Martinlogan i Manuel d'utilisateur télécharger pdf (Page 7)

Stand Options 7

NOTE: The Cinema i is intended for use with its stand

attached in almost all installation options. Stand removal

instructions are provided in case you are using a custom

installation that does not require the use of the stand.

Required hardware (included):

(4) #8 x

/4” Phillips head wood screws, (4) hollow rubber

bumper feet

Required tools (not supplied):

/32” Allen tool, #2 Phillips head screw driver

WARNING! For safety reasons, when the Cinema i

is used without its stand, it is necessary to install the

rubber bumper feet (included in the instructions

box). The rubber feet help to prevent the Cinema i

from sliding and causing possible injury or dam-

age to the unit. Once the rubber bumper feet are

installed they should not be removed from the

Cinema i even if the mounting stand must be

reinstalled. The mounting stand can attach to the

Cinema i with the rubber bumper feet installed.

1 Prepare a flat surface with padding and sheets to protect

the Cinema i as you work on it. Disconnect any wires

and carefully place the Cinema i upside down on the

work surface, using books or pieces of cardboard to

keep the speaker from rocking.

2 Using the Allen tool remove 6 Allen bolts (3 from each

side) from the Cinema i stand (figure 5, step A).

3 Remove the stand (figure 5, step B).

NOTE: The Cinema i uses 2 types of rubber feet. The feet

refered to in the following step are large and hollow in the

middle so that a screw can pass through.

4 To install the hollow rubber bumper feet, locate the 4

small pilot holes on the bottom of the Cinema i. Insert a

#8 x

/4” Phillips head wood screw through a rubber

bumper (the wider flat surface should face the speaker

cabinet) and screw the bumper into a pilot hole. Repeat

until all 4 feet are installed. The Cinema i is now ready

for use without the stand (figure 5, step C).

Installing the Stand

NOTE: The Cinema i is intended to be used with its stand

attached in almost all installation options. Stand installation

instructions are provided in case the stand was removed.

NOTE: If the large, hollow rubber bumper feet described

in step 4 of ‘Removing the Stand’ have been installed on

the bottom of the Cinema i cabinet leave them in place

when re-installing the stand.

NOTE: The Cinema i uses 2 types of rubber feet. The feet

refered to in ‘Installing the Stand’ are small and mushroom

shaped and are installed on bottom of the metal stand.

Required hardware (included):

Assembled stand, (4) small mushroom shaped rubber feet

(may already be installed), (6)

/8“ x

/32” Allen tool button

head bolts

Required tools (not supplied):

/32” Allen tool

Removing the Stand

Figure 5. Removing the Cinema i stand.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Martinlogan i Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Microphones Martinlogan i