Martinlogan i Manuel d'utilisateur télécharger pdf (Page 8)

8 Stand Options

1 Prepare a flat surface with padding and sheets to protect

the Cinema i as you work on it. Disconnect any wires and

carefully place the Cinema i upside down on the work

surface, using books or pieces of cardboard to keep the

speaker from rocking.

2 Line up the 6 holes on the metal brackets (3 per side)

with the threaded inserts on the bottom of the Cinema i

(figure 6, step A).

3 By hand, thread

/32“ Allen bolts into the front 2 threaded

inserts (1 per side) that are nearest the woofers. Then,

thread in the remaining 4 bolts (2 per side) and tighten

each one with the

/32” Allen tool (figure 6, step B).

4 Make sure that the stand’s 4 small rubber feet are installed

in the 4 outer holes located on bottom of the stands

center piece. If the small rubber feet have been removed

from the stand they can be easily reinserted by slightly

moistening the feet and twisting them into the holes

with firm pressure (figure 6, step C).

5 Place the Cinema i in the desired location. Make certain

it is stable, secure, and protected from being bumped.

NOTE: These instructions describe how to remove the stand

from the Cinema i and mount it to the wall. MartinLogan

recommends using 6 wall anchors to secure the Cinema i

to the wall. Most installations will use the outer 4 holes and

two center holes. The outer two sets of holes are 16” on

center. If any of the sets of holes hits a stud, it is recom-

mended to directly screw into the stud.

Required hardware (included):

(6) wall anchors, (6) 1“ Phillips head screws

Required tools (not supplied):

/32” Allen tool, a 2 ft. level or a 2 ft. board and a small

level, an electric drill and

/4“ and

/8“ drill bits, Phillips

screw driver

NOTE: These instructions assume the mounting surface is

of wood frame and standard sheetrock construction. If you

wish to mount the Cinema to another type of material or

construction, you should consult a bonded contractor.

WARNING! This operation requires 2 people. Do

not attempt to install your Cinema i on a wall or

ceiling by yourself

WARNING! For safety reasons, the Cinema i is

shipped with four small rubber feet installed on

the bottom of the metal stand. If the stand is being

mounted on a wall, these small rubber feet must

be removed.

1 Prepare a flat surface with padding and sheets to protect

the speaker as you work on it. Disconnect any wires and

carefully place the Cinema i upside down on the work

surface, using books or pieces of cardboard to keep the

speaker from rocking.

2 Make sure that the 4 small rubber feet on the bottom of

the Cinema i’s metal stand are removed. If they are not,

do so at this time by gently pulling and rocking them out

of the holes (figure 7, step A).

Mounting the Cinema i On A Wall

Figure 6. Attaching the Cinema i stand.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Martinlogan i Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Microphones Martinlogan i